CS1- Jacking switch, magnetic induction switch, cylinder sensor
model
Technical parameters
CS1-J
The most powerful
10W
Working voltage
Two-wire system :5-250V DC/AC
Detection distance
(The actual detection distance shall prevail. The increase or decrease of the detection distance mainly depends on magnetic steel)
Back to the poor
Less than 30% of the detection distance
Standard detection body
8 x 5 magnetic steel
The response time
10ms
The environment temperature
-20℃~80℃
Vibration resistance
10-55Hz (cycle per minute) complex amplitude 1mm, x, V, z all directions 2 hours
Impact resistance
500M/S2 (50G) x, y and z three times in each direction
Repeat accuracy
It's about 10% of the deviation
Protection grade
IPG7
Magnetic switch CS1-J means it is induced by magnet. This magnet is magnet. There are several kinds of magnets. The switch is a reed pipe. Dry spring tube is the abbreviation of dry tongue yellow tube, is a passive electronic switch element with contact, has the advantages of simple structure, small volume for control, its shell is generally a sealed glass tube, the tube is equipped with two iron elastic reed electric plate, also filled with a kind of inert gas called metal rhodium. Normally, the two reeds made of special materials in the glass tube are separated. When a magnetic substance is near the glass tube, under the action of magnetic field lines, the two reeds in the tube are magnetized and attract each other to contact, and the reeds will pull together, making the circuit connected by the node connected. When the external magnetic force is gone, the reeds are separated by their own elasticity, and the circuit breaks. Therefore, as a line switch device controlled by magnetic field signal, the reed pipe can be used as a sensor, used for counting, limit, etc. (in the security system is mainly used for the production of door magnetic, window magnetic), but also widely used in various communication equipment. In practice, magnets are usually used to control whether the two pieces of metal are connected or not, so it is also called "magnetron".
The CS1-J series is divided into two lines (with contact dry yellow tube) and three lines (without contact transistor, MPN type and PMP type)
